If you were Registered and logged in, you could reply and use other advanced thread options
I recently bought a media center extender, but I can get it to work with my
HP computer.
Going through the setup everything seems to go fine until it tries to verify
the "security ". At that point the media center extender shows a "general
failure" with the "error code 2003" and reboots.
Looking at the event log on the media center computer, I get the following
messages:
AffConfirm RQ- Device - successfully
affiliated
ERROR: KeyExch RQ3 Device - There was
an error processing this request. Error code 0x80004005
I switched all my firewalls off, I tired wired connection, a wireless
connection, a different router, I even tried a direct x-over cable between
the PC and the extender to make sure the hub was not interfering, but no
success. It keeps giving me this error message.
Any suggestions??
Thanks
HP computer.
Going through the setup everything seems to go fine until it tries to verify
the "security ". At that point the media center extender shows a "general
failure" with the "error code 2003" and reboots.
Looking at the event log on the media center computer, I get the following
messages:
AffConfirm RQ- Device - successfully
affiliated
ERROR: KeyExch RQ3 Device - There was
an error processing this request. Error code 0x80004005
I switched all my firewalls off, I tired wired connection, a wireless
connection, a different router, I even tried a direct x-over cable between
the PC and the extender to make sure the hub was not interfering, but no
success. It keeps giving me this error message.
Any suggestions??
Thanks
One more point, I have 2nd harddrive in computer which is a dynamic drive (it
only contains data, no operating system files and has its own drive letter).
Since I know that dynamic drives can cause problems, I disconnected the drive
but still the same problem. Can this still have anything to do with my
dynamic drive? Is there anything else I need to do to get around the dynamic
drive problem? The dynamic drive disappeared from the disk manager after I
disconnected it. It seemed to me that this would have solved any dynamic
drive problem if there would have been one...
Correct?
"Harold" wrote:
only contains data, no operating system files and has its own drive letter).
Since I know that dynamic drives can cause problems, I disconnected the drive
but still the same problem. Can this still have anything to do with my
dynamic drive? Is there anything else I need to do to get around the dynamic
drive problem? The dynamic drive disappeared from the disk manager after I
disconnected it. It seemed to me that this would have solved any dynamic
drive problem if there would have been one...
Correct?
"Harold" wrote:
- LinkSys Media Center Extender disconnection, error code 00010002
- March 30, 2006, 11:15 pm
- Media Extender Error Code 09990204
- September 30, 2006, 12:25 pm
- Error Code 00000204 when trying to Connect Extender to Media Cente
- April 17, 2008, 12:11 pm
- Media Center error code?
- June 20, 2007, 12:00 am
- Linksys Extender - Error Code 204
- July 1, 2005, 6:32 am
- Media Center Guide Error - Code: 33
- December 17, 2005, 1:20 pm
- Error code 21 in media center vista
- September 8, 2007, 6:42 pm
- Media Center xp 2005 Code Error: 3
- January 2, 2009, 5:20 pm
- Error Code 13 on Vista Media Center x64
- November 17, 2009, 1:48 pm
- X5400 Extender - error code 11003
- September 3, 2006, 3:05 pm
- Media Center - Unable to record (Error code: 774)
- October 25, 2007, 3:38 pm
- Guide Sever Error (code: 14) in Media Center
- November 14, 2007, 3:13 pm
- Media Center Guide won't load. Code 13 error
- May 19, 2008, 7:52 pm
- Error Code 00110003 / Extender just stopped working!
- July 20, 2006, 10:31 pm
- Xbox Extender setup fails with error code -209
- November 25, 2006, 10:26 am


XML Sitemap
> HP computer.
>
> Going through the setup everything seems to go fine until it tries to verify
> the "security ". At that point the media center extender shows a "general
> failure" with the "error code 2003" and reboots.
>
> Looking at the event log on the media center computer, I get the following
> messages:
>
> AffConfirm RQ- Device - successfully
> affiliated
>
> ERROR: KeyExch RQ3 Device - There was
> an error processing this request. Error code 0x80004005
>
> I switched all my firewalls off, I tired wired connection, a wireless
> connection, a different router, I even tried a direct x-over cable between
> the PC and the extender to make sure the hub was not interfering, but no
> success. It keeps giving me this error message.
>
> Any suggestions??
>
> Thanks
>